Leak detection and repair across Sydney for 30+ yearsCall or SMS 0412 000 893 · 1choicebm@gmail.com

Leaking shower repair in Parramatta without removing the tiles

A leaking shower in Parramatta, close to our base. We didn't go over the old material: we cut out all the old silicone, raked out the old grout, renewed it, resiliconed every edge and sealed the shower in about 2 hours, without removing a tile.

DuringDuring: Shower floor mid-job, with strips of old silicone cut out from the edges and the floor waste grate lifted
AfterAfter: The same shower with clean grout, new silicone along the edges and hob, a sealed finish and the waste grate back in place
Parramatta shower: old silicone cut out mid-job; regrouted, resiliconed and sealed after

The job at a glance

  • Location: Parramatta, NSW 2150
  • Problem: leaking shower with failed grout and silicone
  • Work: degrouted and regrouted the shower, replaced all the silicone and sealed it
  • Time on site: about 2 hours
  • Back in use: after 24 hours of curing
  • Tiles removed: none
  • Completed: October 2026

We remove the old grout and silicone. We don't go over the top of it

A lot of shower "repairs" just run new silicone or a grout paste over the old material. It looks fine for a while, but the new layer has nothing sound to bond to, so water keeps getting in underneath and the leak comes back. We rake the old grout out of the joints and cut every piece of old silicone out before anything new goes in. That's what makes the repair last.

What the mid-job photo shows

The first photo was taken partway through the job. The strips on the floor are the old silicone we cut out of the corners, the hob and the screen junction. Old silicone like this peels away from the tile once it fails, leaving a gap where water runs behind the tiles. Replacing it completely, rather than running new silicone over the top, is what stops the leak.

What we did

  1. Cut out all the old silicone from the corners, hob and screen junction.
  2. Raked out the old grout.
  3. Regrouted the shower.
  4. Resiliconed every edge and junction.
  5. Sealed the shower and left it to cure for 24 hours.

Leaking shower in Parramatta?

We're based in the Parramatta area and work across Greater Sydney. If the tiles are sound, most leaking showers can be repaired in a couple of hours without removing them. See our Parramatta service area

Every shower is different. We'll inspect yours first and tell you honestly whether a non-invasive repair is right for it.

Leaking shower or balcony?

We'll inspect it and quote for free, anywhere in Sydney. If the tiles are sound, we can usually stop the leak without lifting them. The sealing product we use carries a manufacturer's product warranty of up to 25 years, under the manufacturer's terms.

CallSMSFree quote

Book a free inspection

Prefer to talk? Call 0412 000 893 or send an SMS.

Leave your name, phone number and suburb and we'll call you back to book a free inspection.

Mobile or landline, so we can call you back

Add more details (optional: property type, urgency, photos)

One wide shot of the whole area, then close-ups of the grout, corners and where the water shows up. JPG, PNG, HEIC or WebP, up to 8 MB each.

    By sending this, you agree to us contacting you about your enquiry and keeping the details and photos you send, as set out in our privacy information.

    We'll call you back shortly, 7 days a week. Want to talk now? Call or SMS 0412 000 893.