Leak detection and repair across Sydney for 30+ yearsCall or SMS 0412 000 893 · 1choicebm@gmail.com

Leaking shower repair in Revesby: upstairs shower leaking through the ceiling

An upstairs shower in a Revesby duplex was leaking through the ceiling of the room below. The owner had already tried to fix the floor themselves, but it was still leaking. We regrouted the floor with epoxy grout and resealed the edges in about 2 hours, without removing a single tile.

BeforeBefore: Dark-tiled shower floor after a failed DIY repair, with grey grout smeared over the tile faces and gaps along the edges
AfterAfter: The same shower floor with clean, even epoxy grout joints and resealed edges
Revesby shower floor: failed DIY grout before; epoxy grout and resealed edges after

The job at a glance

  • Location: Revesby, NSW 2212
  • Property: two-storey duplex house
  • Problem: first-floor shower leaking through the ground-floor ceiling
  • Work: degrouted the floor, removed the old silicone, epoxy regrouted, resiliconed the edges and sealed the floor
  • Time on site: about 2 hours
  • Back in use: after 24 hours of curing
  • Tiles removed: none
  • Completed: August 2026

The problem

Water from the upstairs shower was coming through the ceiling of the room underneath. The owner had tried to repair the shower floor, but the leak hadn't stopped.

What we found

The earlier DIY repair hadn't sealed the floor. New grout had been smeared across the faces of the tiles instead of packed into the joints, Many of the grout lines were cracked wide open and had been poorly filled, and the joints where the floor meets the walls and the hob were patchy, with gaps and old, failing silicone. Water could still get through the joints and under the tiles, which is how a shower ends up leaking into the room below.

The tiles themselves were sound and firmly fixed, so the floor didn't need to be ripped up.

What we did

  1. Raked out all the old and DIY grout from the floor joints.
  2. Cut out the old silicone along the edges and corners.
  3. Regrouted the floor with epoxy grout, which is waterproof and much harder-wearing than standard cement grout.
  4. Resiliconed the junctions between the floor, the walls and the hob.
  5. Sealed the floor and left it to cure.

The work took about 2 hours. The shower was ready to use after 24 hours of curing.

The result

No further leaks have been reported since the shower went back into use.

Is your shower leaking into the room below?

A stain or drip on the ceiling under a bathroom is one of the most common signs of a leaking shower. A DIY regrout often doesn't fix it, because the old grout has to come out completely and the edges have to be resealed as well. If the tiles are still sound, we can usually stop the leak without removing them. See our leaking shower repairs

Every job is different. We'll inspect your shower first and tell you honestly whether a non-invasive repair is right for it.

Leaking shower or balcony?

We'll inspect it and quote for free, anywhere in Sydney. If the tiles are sound, we can usually stop the leak without lifting them. The sealing product we use carries a manufacturer's product warranty of up to 25 years, under the manufacturer's terms.

CallSMSFree quote

Book a free inspection

Prefer to talk? Call 0412 000 893 or send an SMS.

Leave your name, phone number and suburb and we'll call you back to book a free inspection.

Mobile or landline, so we can call you back

Add more details (optional: property type, urgency, photos)

One wide shot of the whole area, then close-ups of the grout, corners and where the water shows up. JPG, PNG, HEIC or WebP, up to 8 MB each.

    By sending this, you agree to us contacting you about your enquiry and keeping the details and photos you send, as set out in our privacy information.

    We'll call you back shortly, 7 days a week. Want to talk now? Call or SMS 0412 000 893.